Mitsubishi MOTORS ATTRAGE, Руководство пользователя

Страница: 111 / 222

Manual transmission*
6-24 Starting and driving
6
E00627801140
If the indicator lamp blinks, the Auto
Stop & Go (AS&G) system is malfunctioning
and will not operate.
We recommend you to consult an authorised
MITSUBISHI MOTORS dealer.
E00602002513
The shift pattern is shown on the gearshift
lever knob. Press the clutch pedal all the way
down while shifting gears. To start off, press
the clutch pedal all the way down and shift
into 1st or “R” (Reverse) position, operating
the gearshift lever slowly.
Then gradually release the clutch pedal while
depressing the accelerator pedal.
E00610600312
Always use care to change the gear with the
vehicle speed matched to the engine speed.
Proper shifting will improve fuel economy
and prolong engine life.
Avoid shifting down at high speed, as this
may cause excessive engine speed and dam-
age the engine.
E00610803184
Avoid shifting down at high speed, as this
may cause excessive engine speed (the
tachometer needle into the red zone) and
damage the engine.
Use 5th gear whenever vehicle speed allows,
for maximum fuel economy.
E00602100275
The CVT will automatically and continuously
change its gear ratio depending on road and
driving conditions. This helps achieve
smooth driving and excellent fuel efficiency.
If the indicator lamp blinks
while driving
Manual transmission
*
CAUTION
 Do not put the gearshift lever into the reverse
position while the vehicle is moving for-
ward. Doing so could damage the transmis-
sion.
 Do not rest your foot on the clutch pedal
while driving. Doing so could cause rapid
wear to the clutch.
 Do not coast in the “N” (Neutral) position.
 Do not use the gearshift lever as a handrest,
because this can result in premature wear of
the transmission shift forks.
NOTE
 During cold weather, shifting may be diffi-
cult until the transmission lubricant has
warmed up. This is normal and not harmful
to the transmission.
 If it is hard to shift into 1st, depress the
clutch pedal again; the shift will then be eas-
ier to make.
 To shift into the “R” (Reverse) position from
5th gear, move the gearshift lever to the “N”
(Neutral) position, and then move it to the
“R” (Reverse) position.
 To avoid grinding noises when shifting into
reverse, wait approximately 3 seconds with
the clutch pedal depressed when the vehicle
is stationary.
Changing gears
CAUTION Possible driving speed
Shift point Speed limit
1st gear 50 km/h
2nd gear 95 km/h
3rd gear 140 km/h
4th gear 168 km/h
Automatic transmission
INVECS-III CVT (Intelli-
gent & Innovative Vehicle
Electronic Control System
III)
*