Mitsubishi MOTORS ATTRAGE, Руководство пользователя

Страница: 100 / 222

Engine switch*
Starting and driving 6-13
6
E00631901490
If you press the engine switch without
depressing the brake pedal, you can change
the operation mode in the order of OFF, ACC,
ON, OFF.
E00632801773
After approximately 30 minutes has elapsed
with the operation mode in ACC, the function
automatically cuts out the power for the audio
system and other electric devices that can be
operated with that position.
When you open driver’s door or the engine
switch operate again, the power is supplied
again.
NOTE
 Your vehicle is equipped with an electronic
immobilizer.
To start the engine, the ID code which the
transponder inside the key sends must match
the one registered in the immobilizer com-
puter. Refer to “Electronic immobilizer
(Anti-theft starting system)” on page 3-3.
Changing the operation mode
CAUTION
 When the engine is not running, put the oper-
ation mode in OFF. Leaving the operation
mode in ON or ACC for a long time when
the engine is not running may cause the bat-
tery to be discharged, making it impossible
to start the engine, lock and unlock the steer-
ing wheel.

When the battery is disconnected, the current
operation mode is memorized. After recon-
necting the battery, the memorized mode is
selected automatically. Before disconnect-
ing the battery for repair or replacement,
make sure to put the operation mode in OFF.
Be careful if you are not sure which opera-
tion mode the vehicle is in when the battery
is run down.
 The operation mode cannot be changed from
OFF to ACC or ON if the keyless operation
key is not detected to be in the vehicle. Refer
to “Keyless operation system: operating
range for starting the engine and changing
the operation mode” on page 3-9.
 When there is the keyless operation key in
the vehicle and the operation mode isn’t
changed, the keyless operation key may have
worn out.
NOTE
 If the operation mode cannot be changed to
OFF, perform the following procedure.
1. Move the selector lever to the “P” (PARK)
position, and then change the operation
mode to OFF (for vehicles with CVT).
2. One of the other causes could be low battery
voltage. If this occurs, the keyless entry sys-
tem, keyless operation function, and steering
wheel lock will also not operate. Contact an
authorised MITSUBISHI MOTORS dealer.
ACC power auto-cutout func-
tion
NOTE
 When ACC power supply automatically
stops, the steering wheel can’t lock and you
can’t lock and unlock the doors by the key-
less entry system.
 It is possible to modify functions as follows:
• The time until the power cuts out can be
changed to approximately 60 minutes.
NOTE