EN-31
SIGNAL menu (continued)
•
Though horizontal strips may appear on the enlarged projected image, such symptom is not a malfunction.
•
When you change the horizontal or vertical position to a large extent, noise may appear.
•
The adjustable range of the vertical position varies depending on the type of the input signal. Though the image may stay in the
same position even when the setting value is changed, such symptom is not a malfunction.
•
SHUTTER will not work correctly during keystone adjustment.
•
When you increase the setting value of OVER SCAN, noise may appear on the screen.
•
Menus may not be displayed partially depending on the settings of HORIZ. PIXELS and VERT. LINES in the RESOLUTION
(MEMORIZE) menu. In this case, execute AUTO POSITION. (See page 21.)
Important:
•
You can set the IMAGE menu and the SIGNAL menu only when the signal is supplied.
•
When the 3D in the IMAGE menu is set to ON, you cannot set OVER SCAN and SHUTTER.
ITEM
SETTING
FUNCTION
USER
ENTER
The USER menu is displayed for the following adjustments.
CLAMP POSITION
1-255
Use to correct solid white or solid black in the projected image.
CLAMP WIDTH
1-63
Use to correct solid black in the projected image.
VERT. SYNC.
AUTO / OFF
Use to adjust the image when its motion doesn’t run smoothly. Select AUTO for
normal use.
LPF
ON / OFF
Use to select whether or not to enable the LPF. (See page 38.)
SHUTTER(U)
0-20
Use to adjust the image when noise appears on the top part of the image.
SHUTTER(L)
0-20
Use to adjust the image when noise appears on the bottom part of the image.
SHUTTER(LS)
0-20
Use to adjust the image when noise appears on the left half of the image.
SHUTTER(RS)
0-20
Use to adjust the image when noise appears on the right half of the image.
