EN-13
3. Select OFF, MIRROR, INVERT or MIRROR INVERT
by pressing the
W
or
X
button.
Front projection, ceiling mounting
For ceiling mounting, you need the ceiling mount kit
designed for this projector. Ask a specialist for
installation. For details, consult your dealer.
•
The warranty on this projector does not cover any
damage caused by use of any non-recommended
ceiling mount kit or installation of the ceiling mount
kit in an improper location.
•
When using the projector mounted on the ceiling,
set IMAGE REVERSE in the INSTALLATION menu to
MIRROR INVERT. See page 28.
•
When the projector is mounted on the ceiling,
images may appear darker than those projected in
the case of tabletop mounting. This isn’t a product
malfunction.
Ceiling mount installation
If you wish to install the projector using a ceiling mount,
please use the screw holes as the illustration shows.
Important:
•
Screws are not included. Please obtain the
appropriate screws for your type of ceiling. (M4
diameter)
•
It is recommended that you keep a reasonable
space between the bracket and the projector to
allow for proper heat distribution.
Caution:
•
Installation must be done by a qualified professional.
When the project is installed on the ceiling using the
ceiling mount kit, it is recommended to hold the
mount kit and the projector using a metal bar or wire
in addition to the mount kit fixing screws to prevent
the projector from falling due to an earthquake or
other cause. For that purpose, use a metal bar, wire,
or screw that bears a load of at least 40kgf. When
using a metal wire, secure one end to a screw hole
marked with an arrow on the rear terminal panel and
the other end to the mount kit. (Don’t use screw
holes without arrow marks.) On this case, make sure
that the screw is inserted in the projector at least
5mm. The length of the screw should be 20 mm or
shorted. Also make sure that no electrical current is
flowing in the mount kit due to current leakage or
other cause.
Rear projection
Ask a specialist for installation. For details, consult your
dealer.
•
For rear projection, set IMAGE REVERSE in the
Installation menu to MIRROR. See page 28.
Caution:
•
Placing the projector directly on a carpet impairs
ventilation by the fans, causing damage or failure.
Put a hard board under the projector to facilitate
ventilation.
•
Place the projector at least 50 cm (or 20 inch) away
from the wall to prevent the air inlet grille and the air
outlet grilles that emit hot air from being blocked.
•
Do not use the projector in the following locations
and manners, which may cause fire or electric
shock.
• In a dusty or humid place.
• In a vsideways or upside-down position.
• Near a heater.
• In an oily, smoky, or damp place such as a
kitchen.
• In direct sunlight.
• Where the temperature rises high, such as in a
closed car.
• Where the temperature is lower than +41°F (or
+5°C) or higher than +95°F (or +35°C ).
Important:
•
Do not apply force to the lens, because the lens may
be damaged.
•
Be sure to use this projector at an altitude of less
than 1500 meters.
