EN-19
Power-on
1. Turn on the device connected to the projector first.
2. Plug the power cord in the wall outlet.
• The POWER indicator lights up.
• If the power cord is unplugged from the wall outlet
before the projector is cooled down completely
after use, the fans may start rotating when the
power cord is plugged in next time and the
POWER button may not function. In this case,
wait for the fans to stop and press the POWER
button to light the indicator.
3. Press the POWER button on the control panel or the
ON button on the remote control.
• It may take about one minute for the lamp to light
up.
• The lamp occasionally fails to light up. Wait a few
minutes and try to light the lamp again.
• After the POWER button is pressed, the image
may flicker before the lamp becomes stable. This
is not a product malfunction.
• Regardless of the setting of LAMP MODE in the
INSTALLATION menu, the STANDARD lamp mode
is activated by default whenever the projector is
turned on. The LAMP MODE is set to either
STANDARD or LOW depending on the setting last
selected, and you cannot switch the LAMP MODE
in about one minute after the lamp is on.
Important:
•
If the lamp exceptionally turned off due to the power
interruption or voltage drop, it can happen that the
lamp does not turn on even if you switch again the
power supply on. In that case, please pull the
electric cord out of the consent and put it again in
the consent about 10 minutes later.
•
Do not cover the lens while the lamp is on.
•
The projector starts warming up when the POWER
button is pressed. During the warm-up process,
images may appear dark and no commands are
accepted.
•
By blinking red, the STATUS indicator indicates that
the lamp should be replaced soon. Replace the lamp
when the STATUS indicator blinks red. (See page
57.)
•
Images may not be projected with good quality in an
extremely hot or cold environment. (This is not a
product malfunction.)
•
In order to ensure the safety in case of trouble with
the projector, use an electrical outlet having an earth
leakage breaker to supply the power to the projector.
If you do not have such outlet, ask your dealer to
install it.
4. Adjust the focus by turning the focus ring.
• You are recommended to adjust the focus at the
screen center.
5. Select an input source.
• Press the SOURCE button.
• When the SOURCE button is
pressed, the SOURCE dialog
shown right appears. Press
the
S
or
T
button to select
an input and press the
ENTER button.
• The projector automatically selects the
appropriate signal format. The selected signal
format is displayed on the screen.
• You cannot change the input source while the
menu is being displayed.
• Though it may take some time before an image is
displayed on the screen depending on the type of
the input signal, such symptom is not a
malfunction.
• Images may not be projected in the correct
position, depending on the type of the input
signal. In such a case, press the AUTO POSITION
button. (The AUTO POSITION only works when
the input is COMPUTER (1 or 2).) (See page 21.).
• When COMPUTER 1 or COMPUTER 2 is chosen
as the source, images supplied from the
computer may flicker. Press the
W
or
X
button on
the remote control to reduce flicker, if it occurs.
(Fine adjustment).
Indicator
STATUS
POWER
Condition
Stand-by
-
Red
When the lamp is on.
Green
Green
3,
1, 2
5
TIMER
EFFICIENT
MODE
AUTO
POSITION
SEARCH
ENTER
3D
ASPECT
SOURCE
ON
STANDBY
MENU
COLOR.E
KEYSTONE
MAGNIFY
E-ZOOM/
E-SHIFT
AV MUTE
FREEZE
INFO.
VOL
1, 2
3
5
4. Focus
6. Zoom
