Mitsubishi Electric MR-J2-03B5, Инструкция по эксплуатации

Страница: 45 / 113

3 - 18
3. SIGNALS AND WIRING
3.9 Control axis selection
Use the axis select switch (CS1) to set the control axis number for the servo. The control axis number set
to CS1 should be the same as the one set to the servo system controller. If the same numbers are set to
different control axes in a single communication system, the system will not operate properly. The control
axes may be set independently of the bus cable connection sequence.
Set the switch to "F" when executing the test operation mode using servo configuration software.
Axis select switch (CS1)
1
C
B
A
9
8
7
6
5
4
3
2
0
F
E
D
No. Description
0 Axis 1
1 Axis 2
2 Axis 3
3 Axis 4
4 Axis 5
5 Axis 6
6 Axis 7
7 Axis 8
8 Not used
9 Not used
A Not used
B Not used
C Not used
D Not used
E Not used
F Test operation mode