2-44
Confirming the operation
The WORK jog operation and the Ex-T jog operation can be switched by setting the parameters WK1-
JOGMD to WK8JOGMD of each work coordinates system.
The respective operations are as follows.
* The Ex-T jog cannot be used for the 5-axis type. Even when "1" is set in the parameter WKnJOGMD, the
operation is the same as the conventional WORK jog operation.
・ When the [+X (J1)] keys are pressed, the robot will move along the X axis (Xw) plus direction on the work
coordinates system.
When the [-X (J1)] keys are pressed, Move along the minus direction.
・ When the [+Y (J2)] keys are pressed, the robot will move along the Y axis (Yw) plus direction on the work
coordinates system.
When the [-Y (J2)] keys are pressed, Move along the minus direction.
・ When the [+Z (J3)] keys are pressed, the robot will move along the Z axis (Zw) plus direction on the work
coordinates system.
When the [-Z (J3)] keys are pressed, Move along the minus direction.
When the X, Y, or Z keys are used, the operation is the same in the WORK jog and the Ex-T jog modes.
WORK jog operation mode
Conventional WORK jog
Ex-T jog
Parameters WKnJOGMD (n is 1 to8) set-
ting
0 (initial value)
1
XYZ key operation
Moves along each axis of the work coordi-
nates system
Same as the conventional WORK jog
ABC key operation
With the control point position maintained,
the direction changes along the work coor-
dinates system.
While the control point position is
changed, the direction changes on each
axis of the work coordinates system.
＋X
＋Y
＋Z
－Z
－Ｙ
－Ｘ
ツ
ー
ル
長
+Xw
+Yw
+Zw
The jog movement based on work coordinates system
* The direction of the flange will not
change. (6-axis type)
Move the control point with a
straight line in accordance with the
work coordinates system
Work coordinates system
To
ol
leng
th
Controll point
5-axis type/6-axis type
