Fit the main gear assembly and check the
clearance of the unit. The mainshaft must
protrude a small distance from the bottom
of the unit. If the clearance is too large
then add washers 10x16x0.1 046 or 0.2
033. If the clearance is too small then add
washers 5x10x0.1 044.
Fit the aluminium main shaft lock H09 with
hex screw M5x12 034 and add Loctite to
the thread.
Screw in screw
fi
nger-tight and check the
clearance. If necessary add or remove
washers. If everything is slop and bind
free, tighten the screw carefully. Use a
long screw through the upper hole in the
shaft so that the screw can be tightened
properly.
Finally check clearance of freewheel as-
sembly and that there is no play or bin-
ding of the gearwheel.
