Screw the bellcrank with Loctite onto the
holder. Make sure that the slider ball is lo-
cated in the ball housing before tightening.
Check that the tail control rod is right ang-
les to the tail bell crank and the servo arm,
if not adjust the link at the servo until this
is achieved.
Overview of the tail rotor with 80 mm Zeal
blades #1052, two hex screws M3x25
D336, four chinese weights 952 and two
lock nuts M3 008.
Overview of the already assembled speed
controller (Hobbywing 50A V3) with Lisi
Telemetry unit (TXE50). XT60 is the re-
commended connector.
Note the wiring layout for the TXE sensor.
