The hex screw is best tightened with a
4mm socket driver and a 1.5mm hex
wrench. Tighten the nut careful do not
over tighten.
Overview of assembled servo arms. Note
the position of the balls for the roll servo
arms and pitch arm.
First
fi
t the elevator servo in the lower left
servo slot. Mount the roll servos after the
tail servo. To make
fi
tting the tail servo
easier hold nuts with a pair of pliers.
All servos are attached with four hex
screws M2x12 099 and large washers M2
D517 to the rear canopy plate.
These screws are small enough to give a
small degree of adjustment for mounting
of different servos.
