Overview of components for the blade grip
assembly.
Push the blade grips onto the mounting
ring and align the four holes. If the blade
grips are tight, warm them up with a hair
dryer. Fit 4 hex lens screws M3x6 D199
and shim washer 3x6x0,2 455 and mount
them loosely with Loctite. Before tighte-
ning pull both blade grips with force out-
wards to eliminate endplay. This can be
done by
fi
tting the blade bolts and looping
a rope through them to create the requi-
red pulling force. When done tighten the 4
screws on each blade holder.
Assemble the left and right roll rods H35
with a large ball link D72 and a ball link
with bolt D324. The ball link with ball is
placed on the end with the left hand thread
(with turned ring). When
fi
tted, the length
can be adjusted by turning the rod clock-
wise to reduce the blade angle and coun-
ter clockwise to increase blade angle.
Fully screw in the 52mm H37 rod into
the SRC arm H36 with Loctite, so that no
thread is visable outside the unit (this is to
avoid the risk of breakage in the threaded
area). On the other end add a ball link with
bolt D324. This rod has standard threads
(clockwise turning).
