Add the tailservo holder H27. You may
have to
fi
le the corners of the slot in the
rear plate, but only a small amount. The
holder should
fi
t in the plate snugly. As
soon as the holder
fi
ts into the slot (note it
is slightly angled) as shown in the picture
it should be secured with two hex screws
M3x10 D328 on the mounting block H25.
For this a ball wrench is useful but not
essential.
After tightening press the tailservo holder
downwards so that the lower holes of the
mounting block line up with the holes in
the frame.
Now attach two hex screws M3x8 D197
in the holes and tighten all four screws
carefully, do not over tighten as this part is
plastic.
Fit the rear canopy plate with two hex
screws M3x8 D197 and Loctite. After
tightening you can also tighten the outer
screws of the plate connectors.
