Bend the tail protection wire S868 over
a one inch round bar and to an angle of
about 150 degrees. Before bending the
wire make sure that the eyelets are in line
with the bend so that there are no align-
ment problems when
fi
tted later.
Fit the wire over hex screw M3x35 D338
with washer M3 002 under the screw head
and shim washer 3x6x0,5 D312 on the
other side of the eyelet.
Now push the screw through the tail rotor
housing.
Add a shim washer 3x6x0,5 D312 to the
other side and add Loctite to the screw
thread.
Fit the bellcrank holder D560 .
