The tail control rod H49 is supported
through two small mounts H46 and one
large mount H45 at the front. Slide the
wire through the three mounts. The dis-
tance of the front mount to the frame is
6-8mm. Use the supplied insulation tape
to
fi
x the mounts to the tail boom.
It is important that the wire is mounted as
straight as possible to prevent binding.
The distance between the rear of the cen-
ter block and the front edge of the tail rotor
housing is 295mm.
The distance between the rear of the rear
block to the front edge of the tail rotor
housing is 80mm.
Screw two ball links S996 onto the tailrod.
Make sure the the tailrod is fully screwed
in with no threads showing especially at
the rear end as vibration can fracture the
rod.
Remove the tail bellcrank from the holder
to
fi
t the ball link. Then check that there
is smooth and free operation of the link. If
not, as before use a pair of pliers to gently
squeeze the link.
