The rear end of the holder is attached with
a lens screw M3x6 D199 and Loctite on
the thread.
The unattached end of the protection wire
is
fi
xed in place with a hex screw M3x6
D196 and shim washer M3 002 under the
screw head.
Two ball links 385 are screwed on the
tailslider H52. Then slide the unit on to the
tailrotor shaft and check for smooth move-
ment on the shaft.
Mount the bellcrank with hex screw M3x25
D336 and spacer bush H42 on to the
bellcrank holder and check that the ball
bush on the bellcrank is located in the
slider ball. Note do not use Loctite at this
stage.
Now assemble the tailrotor as shown on
the next page.
