9
adjusting
or
Move the cursor to adjust the frequency step size
,
Then to adjust
the frequency of the output waveform by rotating the "ADJUST" knob.
图
2-4
3
、
Setting the amplitude of CH1
In the main interface
,
Press
Button after
,
The magnitude of the
interface will appear in a cursor set
,
Click
or
Button, It is possible to move the
cursor position, rotate "ADJUST" knob to adjust the amplitude of the output
waveform, as shown below:
Drawing 2-5
Wherein, 05.00V refers peak to peak. In this range setting function mode, the
maximum amplitude of 20V, minimum 0.20V, the minimum step value 0.01 (10mV);
as shown in a state 2-6
,
Press
-20dB Attenuation state of the incoming signal, the
output signal of a maximum of 2.000V, the minimum value of 0.005V, the minimum
step is 0.001V (1mV).
图
2-6
4
、
Setting bias of CH1