5/3/2018
Mutable Instruments | Links
https://mutable-instruments.net/modules/links/manual/
1/2
Links
User manual
INSTALLATION
Links requires a -12V / +12V power supply (2x5 pin connector). The ribbon cable connector must be
aligned so that the red stripe of the ribbon cable (-12V) is on the same side of the module’s power header
as the “Red stripe” marking on the board. The module draws 15mA from both the +12V and -12V supply
rails.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.
This device meets the requirements of the following standards: EN55032, EN55103-2,
EN61000-3-2, EN61000-3-3, EN62311.
1:3 SECTION
This section of the module is a buffered multiple. The signal patched to the
IN
input is duplicated, without
voltage drop, to each of the three
OUT
outputs.
This section can be used to send the note CV from a keyboard, sequencer or MIDI interface to several
VCOs; but it can also distribute an audio signal or modulation to several modules.
2:2 SECTION
