Minebea Intec PR 5230, Инструкция по эксплуатации инструмента

Страница: 271 / 303

12.2.6.11 Register 30, 31: Fixed values (read/write)
Register 30
Fixed value for analog output; value (num) 0 20000 corresponds to
20 mA
Register 31 Fixed value for FixTare, see also SetFixTare , GetFixTare in Chap-
ter 12.2.6.3 .
12.2.6.12 Register 80 89: State-controlled action bits (write)
Note:
For setting bits, see Chapter 12.2.4.3 .
Only setting and resetting of single bits is possible.
When changing a bit from 0 to 1, the corresponding action starts. After handling the
command, the bit must be reset. Application: The master writes cyclically.
The bit is set as Write_Value_Select with the specified number (see Chapter 12.2.4.3 ).
The bit is reset at the specified 128.
Register 80 SetZero Set the gross weight to zero.
Register 81 SetTare Execute taring.
Register 82 ResetTare Reset tare.
Register 83 SetTest Start the ADC test.
Register 84 ResetTest Finish the ADC test.
Register 85 ResetPwf Reset the PowerFail bit (Register 1; the bit was
set after power on).
Register 86 SetFixTare Taring with weight in numerical address D 31
"Fixtare."
Register 87 GetFixTare The current gross weight is copied into numeri-
cal address D31.
Register 89 ResetError The CmdError error bit is reset.
12.2.6.13 Register 112 121: Transition-controlled action bits (write)
For setting bits, see Chapter 12.2.4.3 .
As soon as the bit was set, it is reset internally and the operation is handled; this is
transition-controlled (for writing once).
The bit is set as Write_Value_Select with the specified number (see Chapter 12.2.4.3 ).
Register 112 SetZero
Register 113 SetTare
Register 114 ResetTare
Register 115 SetTest
Register 116 ResetTest
Transmitter in field housing PR 5230 12 Fieldbus interface
Minebea Intec EN-268