MIMAKI CG-100SRIII, Руководство по эксплуатации

Страница: 94 / 172

3-44
Change the cutting (plotting) order
You can reorder or sort the cut data that has been sent from the host computer to change the order for cutting
(SORTING function).
Suppose that there is data that you want to cut just like drawing a picture with a single stroke, according the
order in which data is sent from application software. But in case you cannot do it in one continuous pen stroke,
you can change the cutting order to make it.
(This function may not be supported depending on the firmware version.)
You cannot perform such one-stroke cutting in the following cases
Some applications software send data to the plotter in the order that the data has been created and edited.
• For example, in case you have modified the data read in via scanner, you cannot cut it in one stroke as the
modified part is cut later.
When you want to cut after SORTING
With the sorting function, the plotter handles a piece of data corresponding to each cutting operation that starts
with pen down and ends with pen up as one block. After the completion of cutting one block, the plotter will
perform cutting of another block whose starting point is closest to the finished block.
For data transmitted from the host computer, the starting position and cutting direction will not be changed.
● : Starting point of data = Starting point of cutting
Arrow : Direction of data = Cutting direction
Number : Block cutting order
With the SORTING function, you can perform the following.
Set the SORTING function to “ON,” and then the following functions become effective.
Auto feed function :
This is to detect the length of data to be cut, and to draw out a sheet with that data length in advance.
Area Control function :
This is to previously specify an area and to cut by priority a block data that can be contained in that area. When
the data that can be included in that area runs out, the plotter expands the area to gradually perform cutting in
the sheet feed direction.
Set SORTING .
1
Press the key in the local mode.
Specified area With area specified
With no area
specified
Cutting
order
Cutting
order
FUNCTION