MIMAKI CG-100SRIII, Руководство по эксплуатации

Страница: 44 / 172

2-20
4
Retain the roll sheet with the roll holders.
• Move the roll holders to both ends of the roll, respectively, and
secure them by tightening the screws.
• Locate the roll holders 2 to 3 mm away from the respective roll
ends.If the roll holders are fixed pressed against the roll ends,
there may be a case where the roll cannot turn and thus the
sheet cannot be feed.
5
Lock the roll stopper.
• Push the lock lever toward the rear of the main unit to lock the
stopper.
• The roll stopper prevents the roll from turning when you draw
out the sheet.
6
Hold the sheet.
(1) Pull the sheet to take up the slack in it.
(2) Check that the sheet is set without slacks and then move
down the clamp lever to the front.
• If the plotter has been turned on: The suction fan will rotate to
retain the sheet by suction.
• If the plotter has been turned off:
The suction fan will not rotate. It is, therefore, necessary to tilt
the clamp lever toward the front of the unit while retaining the
sheet with your left hand to prevent the sheet from warping.
7
Release the roll stopper.
• Push and pull the stopper to the front of the plotter.
• If you do not release the roll stopper, the buzzer sounds during
sheet feeding and the plotter stops.
Do not place
too near
Roll holder
Rock
Release