MIMAKI CG-100SRIII, Руководство по эксплуатации

Страница: 46 / 172

2-22
Test cutting (plotting)
Execute test cutting (plotting) to confirm the tool conditions.
In the test cutting, the plotter cuts two squares.
1
Confirm that the plotter is in the local mode.
2
Press the key a few times to select
[SQUARE CUT].
3
Press the key .
• The plotter will execute test cutting (plotting) and then return to the local mode display.
Change the settings of the cut conditions according to the test cutting (plotting) results.
• When the cutter blade is worn and dull, you can use it temporarily by enhancing the value of
PRESSURE. However, you are recommended to replace the worn cutter blade with a new one to
ensure a satisfactory cutting quality.
• When the tool conditions are proper, the results of test cutting (plotting) are as follows:
• The two squares are cut perfectly.
• The base sheet remains uncut.
• No corner of the squares is rounded.
• No corner of the squares is curled-up.
Cut Condition Cause Solution
Some parts uncut.
The blade is lifted above the sheet
because of a too high cutting speed.
Lower the speed. (
P.2-10
).
Tighten up the knob for the tool holder.
(
P.2-5).
The base sheet has
been cut.
Too high pressure. Lower the pressure. (
P.2-10
).
Too large protrusion of the cutter
blade. Adjust the protrusion of the cutter blade.
(
P.2-4).
Any of the square
corners rounded.
Improper OFFSET value.
Adjust the OFFSET value so that it suits the
cutter blade in use. (
P.2-10
).
Any of the square
corners curled-up.
The protruded cutter blade is too
much.
The cutting pressure is higher.
The [COMPENSATION PRESSURE
OFFSET value] is large.
More than two out of the above fall
under this category. Adjust the protrusion of the cutter blade.
(
P.2-4).
Adjust the cutting pressure. (
P.2-10
).
Adjust the ADJ-PRS OFS value.
(
P.3-78, P.3-83).
FUNCTION
ENTER/HOLD