MIMAKI CG-100SRIII, Руководство по эксплуатации

Страница: 43 / 172

2-19
1
2
Basic Operation
s
4
5
6
Setting a sheet
How to Place the Roll Sheet (CG-100SRIII/CG-130SRIII)
If you want to use the roll sheet, you must mount the roll-placing table.
1
Move down the clamp lever to the rear.
2
Set the roll bars on the roll stays.
• Set each roll bar so that the side provided with a projection is
located on the left side as viewed from the rear of the plotter.
Select the groove 1 or 2 to set one of the roll bars depending
on the outside diameter of the roll sheet to be used.
• If the outside diameter of the roll sheet is 3 inch or more, place
the roll bars in the grooves 1 and 3.
• If the outside diameter of the roll sheet is less than 3 inch,
place the roll bars in the grooves 2 and 3.
3
Load a roll sheet.
(1) Place a roll sheet on the roll bars.
(2) Pass the leading edge of the sheet onto the platen and
adjust the location of the pinch rollers to the sheet width.
• Locate each of the pinch rollers 5 mm or more inside the sheet
edge; other-wise, the sheet can slip off the pinch rollers while it
is being fed.
• Keep the roll bars level when lifting up to move the groove in which the roll bars are set.
Lifting up a roll bar at an angle can damage the rollstay Assy.
Roll bar
Rollstay Assy
Projection
1
2
3
Roll sheet