MIMAKI CG-100SRIII, Руководство по эксплуатации

Страница: 133 / 172

3-83
1
1
3
Useful Function
5
6
Miscellaneous Settings
Dummy Cutting
The plotter executes dummy cutting in front of the pinch roller that is
located on the side closer to the current location of the carriage.
Set the dummy cut function to OFF if you do not want to dummy-cut
the sheet that is to be used with characters cut out.
Sheet Setting
Do not cut (plot) a heavy or wide sheet at a high speed; otherwise the sheet may deviate.
Cutting (plotting) a heavy or wide sheet at a high speed may also result in the [ERR401 MOTOR B] error.
In such a case, select [HEAVY] in the sheet setting.
Compensated Pressure Offset
Some part of the sheet remains uncut if the pressure to bring the cutter blade down into the sheet is too low.
Some part around a corner of 120 degrees or less may remain uncut when an eccentric blade (available as an
option) is used.
This problem can occur because of such an intended operation that the cutting pressure automatically drops
(to approximately 5 g) around a corner to prevent the sheet from rising.
Some part may remain uncut if the cutting pressure is too low for the cutter blade to turn in the designed
direction smoothly. In such a case, make setting to raise the cutting pressure for smooth cutting around
corners.
If the pressure is too high and the joint positions of cut segments are outstanding, you can make it obscure by
decreasing the pressure.
• The default setting of the dummy cut function is ON.
If you set the dummy cut function to OFF, execute test cutting to adjust the cutter blade orientation
prior to cutting. (
P.2-22
)
Pinch Roller
Dummy cutting