Miller Ag-Bag G6170, Руководство оператора

Страница: 86 / 96

80
Troubleshooting
Problem Cause Solution
Rotor stops rotating, PTO
shaft continues to turn.
Conveyor apron slows
down or stops.
Brakes fail to hold cable
drum at proper tension.
Conveyor fails to slide
down to operating position.
Bag damage while bagging.
Shear bolt on PTO shaft bro-
ken.
Build up of product around
lower apron shaft.
Hydraulic drive motor worn or
seals leaking.
Conveyor apron out of adjust-
ment.
For Split Conveyor: Upper
drive chain out of adjustment
or broke.
Cable drum brake pads worn.
Hand pump low on hydraulic
oil.
Brake pad contact area on
drum rotor rusty or corroded.
Air in brake lines.
Dirt build up on conveyor
slides.
Cables contacting bag during
operation.
Sharp objects on tunnel.
Tunnel extension lifting loop
stuck in the up position.
Replace shear bolt.
Check for and remove ob-
struction from hopper.
Check for further damage.
Open clean out door and
remove product from shaft.
Repair or replace hydraulic
drive motor.
Adjust apron as required.
Adjust chain tension and/or
replace chain.
Replace brake pads.
Refill hand pump with hydrau-
lic oil.
Clean rust or corrosion from
drum rotor area.
Bleed air from system.
Clean and re-apply grease to
slides.
Adjust cable tension to
change shape of bag.
Place cardboard between
cable and bag at point of
contact.
File or remove sharp corners
or objects.
Place tunnel extension loop
in low
ered position (flat
against extension)