Miller Ag-Bag G6170, Руководство оператора

Страница: 78 / 96

72
3. Drain the hydraulic oil from the main reservoir. Place a suitable container below the plug on the
side of the reservoir opposite the drive chain. Remove the plug. Oil will come out of this drain
with quite a bit of force. Be prepared to move the container as needed. Drain the reservoir
completely.
4. Clean and reassemble the drain plug to the reservoir. Be sure the o-ring seal is not damaged
and tighten securely.
5. Reinstall the drain plug in the underside of the lower reservoir. Tighten the plug securely.
6. Unlatch and open the cover over the hydraulic oil reservoir. Remove the oil filter from the filter
head. Clean the sealing surface of the filter head. Lightly oil the gasket on the new filter. Fill
the filter with new hydraulic oil and spin on to the filter head. Hand tighten to initial contact,
then tighten an additional 3/4 turn. Replacement oil filters are available from your local Ag-Bag
dealer by ordering part number 42.1540167.
Drain Plug
Drain Plug
Oil Filter