Problem solving guide
82
Fault messages at the end of a programme
Message
Possible cause and remedy
Align the machine
The smoothing process which the laundry undergoes
at the end of the programme could not be carried out
properly.
Check that the washer-dryer is aligned correctly as
described in “Installation and connection -
Levelling the washer-dryer”.
Check whether the maximum delivery height of
1.0 m has been exceeded.
If the fault message appears again, contact Miele.
The washer-dryer can still be used but with reduced
functionality.
Check load
There is no laundry in the drum.
The load is too small. The laundry is still damp
because the residual moisture content in the laundry
could not be measured.
In the future use a
Timed drying
programme for
small amounts of laundry.
The amount of laundry exceeded the maximum load
for the selected programme.
Observe the maximum loads listed in the
Programme chart.
Start the "Rinse out
fluff" programme
under "Further
programmes"
The
Rinse out fluff
programme has not been used for
a long time.
Start the “Rinse out fluff” programme as described
in “Washing and Drying” - “Rinse out fluff
programme”.
The messages will appear at the end of the programme and when the washer-
dryer is switched on and need to be confirmed with the
OK
sensor.
Содержание WTZH 730 WPM
Страница 121: ......
Страница 122: ......
Страница 124: ...M Nr 10 867 400 00 en AU NZ WTZH 730 WPM ...