Miele WTZH 730 WPM, Руководство по эксплуатации

Страница: 101 / 124

Installation and connection
101
Water intake
The washer-dryer should be connected
to a mains water supply in accordance
with current local and national safety
regulations. It must be installed
according to AS/NZS 3500.1. Backflow
prevention is already integrated in the
appliance.
The flow pressure must amount to a
minimum of 100 kPa (1 bar) and must
not exceed an overpressure of
1000 kPa (10 bar). If it is higher than
1000 kPa, a pressure reduction valve
must be installed.
Connection to the mains water supply
should incorporate a water tap with a
¾“ threaded union. The tap should be
fitted by a qualified plumber.

The connection point is subject
to mains water pressure.
Turn on the tap slowly and check for
leaks. Correct the position of the
washer and union if necessary.
The washer-dryer is not suitable for
connection to a hot water supply.
Maintenance
Only use a genuine Miele hose that has
been pressure tested to withstand at
least 14,000 kPa should you ever need
a replacement.
In order to protect the water inlet
valve, the dirt filter in the union nut at
the open end of the inlet hose must
not be removed.