Cleaning and care
71
The interior lighting and cooling fan
remain switched on for the whole
duration of the process.
At the end of the activation phase a
buzzer will sound.
Rinsing the steam injection system
after the activation phase
After the activation phase the steam
injection system must be rinsed out to
remove residues of descaling solution.
To do this approx. 1 litre of fresh tap
water is pumped through the steam
injection system three times and is
collected in the universal tray.
Take the universal tray with the
collected descaling agent out of the
oven and empty it. Place the tray
back in the oven again on the top
shelf level.
Remove the plastic tube from the
container.
Remove the container, rinse it out
thoroughly and fill it with approx.
1 litre of fresh tap water.
Replace the container in the oven
compartment and secure the plastic
tube in the container.
Confirm with
OK
.
The intake process for the
first rinse
will start.
The water is fed through the steam
injection system and is collected in the
universal tray.
Instructions for preparing the
second
rinse
will appear.
Take the universal tray with the
collected rinse water out of the oven
and empty it. Place the tray back in
the oven again on the top shelf level.
Remove the plastic tube from the
container and fill it with approx. 1 litre
of fresh tap water.
Replace the container in the oven
compartment and secure the plastic
tube in the container.
Confirm with
OK
.
Proceed in exactly the same way for
the
third rinse
.
Leave the universal tray with the
collected rinse water from the third
rinse in the oven compartment during
residual moisture evaporation.
