Miele Advanta G2020SC, Техническая информация

Страница: 53 / 221

Technical Information
G1000 / G2000 Dishwashers
4.5 Drain System
4.5.1 Drain Pump
The drain pump M8 is driven by a synchronous motor and located under the cabinet
on the left next to the sump. It is directly activated by the electronic module. In case
of fault, the drain pump M8 is also activated directly via the overflow float switch
B8/3. The drain pump pumps the suds via the non-return valve and the drain hose to
the on-site drain.
During drainage the drain pump M8 extracts water from below the microfine filter.
This reverses the direction of flow through the microfine filter that normally exists
during the cleaning and rinse cycles. Soil particles that have been trapped in the filter
during dishwashing are then flushed out with the drain water.
Pumping limits:
Max. 13’ hose length
Max. 3’ 3” head height
Most faults will cause the program in operation to be interrupted and the drain pump
to start.
If the WaterProof System has been activated, Fault code F70, 6.8.15, the drain pump
continues to operate even after the appliance has been switched off. In this case, the
pump is only switched off when the power source is disconnected.
53