Michco sc8000, Руководство по обслуживанию

Страница: 34 / 225

General Information 33 Service Manual – SC8000
Icon Condition Display Icon
Diesel Glow Plug
Start
The key switch is in the run position and
the glow plugs are activated (heating up)
for their timed 10 seconds. The engine
can be cranked to start when the yellow
attention light and display icon go out.
Controller Non-
critical Fault
The driver box (main control board)
has sensed specific system component
failure(s) and displays a two-digit
number and the wrench symbol. See
the
Control System/Main Control
Board Fault Codes
for a description
of the fault codes and recommended
troubleshooting procedures. Note that
when non-critical faults exist, hour meter
will be displayed in rotation with faults,
300:1
Recovery Tank Full
The tank float has sensed a high water
level. The operator needs to empty the
waste water from the tank. If tank is
empty and the icon is displayed, service
(clean) the tank float (it could be stuck).
Also check the float circuit wiring for an
open.
Warning Displays
Example: The main controller board shows the engine service icon
with a two-digit fault code (38) and wrench symbol. This is a critical
engine fault code that indicates the main control board received a
run-inhibit signal from the ECM (LPG) or governor (diesel) that will
shut down the engine.
Icon Condition Display Icon
Parking Brake
Engaged
The parking brake is engaged. The icon
and warning light will disappear when the
Operator releases the brake.
Diesel Oil Pressure
Low engine oil pressure in the diesel
engine is sensed. Check for possible
causes for low oil pressure such as
engine crankcase level is low, incorrect
oil viscosity, fault in oil pressure switch
S28, excessive engine wear or defective
internal oil pump (relief valve). Note that
this icon display is for the Kubota diesel
engine only.
Warning
Indicator