Micanan PRO-GH, Инструкция по установке и эксплуатации

Страница: 7 / 45

7
1. Install control station away from all moving door parts, within sight of the door and a minimum of 5 ft (1.5 m) from
the ground.
2.
Install entrapment warning sign next to control station.
3.
As a general rule, the door operator should be installed below the drive shaft and as close to the door as possible.
The ideal distance between the operator drive shaft and the door shaft is approximately 12” (30cm) to 15” (38cm).
The operator may be wall/bench mounted or bracket /shelf mounted. These two mounting configurations are
shown below:
4.
Mount the operator to the wall, hood or bench with 3/8” bolts, nuts and washers provided or with lag bolts and
shields if installation requires it. Make sure that operator is secured but do not tighten bolts.
5.
Place door sprocket on door shaft and align with operator drive sprocket but do not insert keyway or set screws.
6.
If an optional chain spreader has been ordered with your operator, install as shown below: