Micanan PRO-GH, Инструкция по установке и эксплуатации

Страница: 13 / 45

13
Single phase operators: The operators leave the factory with correct motor and limit shaft direction according to standard
door installations. However, for special fire door, thru- wall mounting or other special door applications, the motor direction
and limit switch direction may need to be reversed. To reverse the motor rotation, interchange black and white wires going
to motor on the reversing contactor.
3-phase operators:
If door moves in wrong direction, turn off incoming power and reverse any two of the three incoming
power supply leads to correct rotation. Press the open button and then activate the open limit to ensure door stops. If door
does not stop, interchange grey and red wires on open and close limits. Interchange white and grey wires on advanced
open and advanced close limits. Remove blue wire from advanced open limit and place it on N.O pin of advanced close
limit.
4) Adjust limit switch cams:
Using the open/close/stop push button station move door to fully closed and fully open oppositions and set limit cams to
correct position. (See Limit adjustment section D further in this manual for complete detail on the end of travel limit
adjustments).
5) Activate Interface module:
After adjusting the open and close limits and verifying the motor rotation, open the door to the full-open position using the
open push button (Figure below on left).
At this point the close pushbutton wire must now be moved from terminal T6 to T5. Now connect the black wire (with blue
label) to terminal T1 as shown in figure below on right.
Note:
Ensure the door is in the full open position before connecting the black wire. If door is not in full open position and
monitored photo-eyes or safety edge are not connected and operational then door will immediately move in the open
direction.