Micanan PRO-GH, Инструкция по установке и эксплуатации

Страница: 8 / 45

8
7. Install drive chain over sprockets, cut to a suitable length and connect with connecting link.
8.
Lower or raise operator to adjust chain tension so that there is no more than ¼ ” chain slack between sprockets.
Tighten operator mounting bolts.
9.
Carefully re-align sprockets, if necessary and secure keyway and set screws.
10.
Install hand chain by wrapping it through chain guard holes and pocket wheel. Allow chain to hang down towards
floor. Cut chain and connect so that chain is 2’ to 3’ from the floor.
11.
Install chain keeper to wall near hand chain at approximately 4’ from floor. Run disconnect chain through keyhole
of chain keeper and cut excess chain links if required. Attach keyring to end of disconnect chain.
12.
If an optional floor level disconnect lever was ordered in lieu of the chain keeper, mount to wall with suitable
hardware. Attach both chains together using keyring provided. Allow disconnect chain to be slightly slack when
lever is in the up position.
13.
After installation is complete, remove red
Activation pin on reducer breather plug.
IMPORTANT