Micanan PRO-GH, Инструкция по установке и эксплуатации

Страница: 25 / 45

25
3- Using the wing nuts, attach the receiver and transmitter of the photo system to the mounting brackets (with arrow
pointing up). Note that the receiver and transmitter can be installed on the left side or right side of the door.
4- Adjust the position of the transmitter and receiver on the slot of the brackets. Secure the receiver and transmitter to
the mounting brackets as shown in figure 2.
5- Pair the two white wires and the two white/grey wires together from transmitter and receiver.
6- Connect these paired wires to the P1 and P2 terminals on the logic board (or interface module if applicable) as
shown in Figure 3. Use minimum 18 gauge wires and secure the wires to wall or ceiling.
MICANAN N-4 PHOTOCELL (MK00650)
Installation
Note: Photo beams should be mounted as close to the door track inside the door to offer maximum entrapment
protection.
Wall installation:
1. Select a location on the wall no more than 6 inches from the floor to install wall mounting brackets on the left and
right side of the door. Both brackets must be mounted at the same height for proper alignment.
2. Drill holes in the wall and attach brackets to the wall using screws and nails provided as shown in Fig. 1.