MetalTech Jobber Plus, Инструкция по эксплуатации

Страница: 15 / 24

MTCC Jobber Plus P a g e - 1 5
MICRO INCH TIMING
Micro Time mSec
Enter New Time 0010
Press ENTER to Save
Micro Inch
Micro inch is used in die setting. If the control is in inch mode and set to MICRO INCH
the palm buttons may both be held in and the machine will increment ‘jog’ for a timed in-
terval.
To turn on Micro Inch:
The control must be in inch mode. Press and quickly release the Continuous Arm button.
The display will read MICRO INCH MODE.
To turn off Micro Inch:
Press and quickly release the Continuous Arm button.
The interval is programmable. The setting can be adjusted by entering the SETUP menu as
previously described and selecting function MICRO INCH TIME.
The time increments are 1/100 of a second. Adjust to a time that best meets the
machines clutch/brake timing.
User Programmable Outputs
The Jobber Plus version comes with two user programmable output relays. These relays will
come on and go off at any programmed angle (rotary position of the machine). To set the cam
relays enter the SETUP menu as previously described and select the SETUP USER RELAYS
function. After making the selection the LCD will display the following.
Use the UP Arrow key to move from cam angle to cam angle. An < or > will appear next to
the angle to be edited. Pressing the ENTER key saves the angles to Flash Ram. The left two
settings are Cam(1) (relay 1) ON and OFF and the right two are Cam(2) (relay 2) ON and OFF.
Enter any number between 1 and 360. The relays will be energized (contact closed) when the
first angle is encountered and off (de-energized) when the second angle is encountered. The
relay contacts are rated at 6 amps 220 ac/dc. If you need N/C contacts simply reverse the start-
ing and ending angle.
To prevent the relays from going ON and OFF set both on and off angle to 360.
SET USER RELAYS
CAM(1) CAM(2)
025< 270 125 015
Use The Up Key to Select