MetalTech Jobber Plus, Инструкция по эксплуатации

Страница: 10 / 24

Page - 10 J o b b e r P l u s M T C C
Stop angle is within
5 degrees of TDC
TDC stop angle has
been determined for
machine speed #1
Turn Key to FOOT to Save
Cycle machine until
it stops at Mach TDC
PRESS PALM BUTTONS
HOLD UNTIL PRESS TDC
Mach. Pos. Angle 008
PRESS PALM BUTTONS
HOLD UNTIL PRESS TDC
Because of limited space on the display instructions are sometimes truncated to fit the screen.
The display above is asking you to cycle the machine by pressing the palm buttons and hold-
ing them until the machine attempts to stop at TDC. When it stops, the display will show
the angular position in degrees.
The LCD prompts you to cycle the machine until it stops a precisely at TDC. All you need
to do is hold the palm buttons in until the control automatically top stops the machine. If the
machine does not stop at TDC within a few degrees the Display will ask you to cycle the
machine again. Each time the machine comes to a stop the angle is displayed.
Repeat cycling the machine until the control displays the following message.
There will be a delay and then the message.