MetalTech Jobber Plus, Инструкция по эксплуатации

Страница: 12 / 24

Page - 12 J o b b e r P l u s M T C C
Adjusting TDC
There may be times when you will need to make adjustments to the stop angle factor pro-
gramed into the Jobber Plus. But before you do, answer these questions:
Did you check to see if you have the proper counter balance pressure set? Proper counter
balance pressure improves your stopping time and therefore the stopping angle can be more
accurate. It also reduces the wear on the clutch and brake.
Have you gotten machine stop time errors?
If so you probably need to perform mainte-
nance on the machine’s clutch and or brake or - your counter balance pressures are not set
correctly.
Have you had to change the stop time setting that was determined in the machine’s
initial setup?
If you had to change the stop time settings the cause is in the clutch/brake or
improper counter balance air pressures.
To make adjustment to a single speed machine follow the instructions from the E-CAM
programming section to get to the programming menu, scroll down to the following screen
and press 3 then ENTER.
.
.
ADJUSTING ACTS # 1
Enter New Stop Angle
Top Stop Offset 289
RELEASE ENTER TO SAVE
*** SETUP MENU ***
3=ADJUST TDC
4=CHANGE PASSWORD
Press DOWN For More
NEW OFFSET SAVED
WARNING: You cannot set the stop angle less then 212 degrees. It will not show but any
setting below 212 degrees is automatically reset to 212 degrees. If the machine is taking
this long to stop, it is unsafe and should be repaired!