MetalTech Jobber Plus, Инструкция по эксплуатации

Страница: 11 / 24

MTCC Jobber Plus P a g e - 11
Variable Speed Machines
The controller requires 4 speed tests for variable speed machines. You will need to divide
the machine’s speed range into four parts - slowest speed, highest speed and two speeds in
the middle. You do not need to know the actual SPM (strokes per minute) If the machine
has a SPM or RPM indicator then write down the speed settings:
EXAMPLE:
Low speed - 40 SPM, 2nd speed - 60 SPM, third speed - 90 SPM, highest
speed - 120 SPM.
If you do not have a digital speed readout, mark the dial for the lowest speed, the 2nd speed,
the third speed, and the highest speed. When changing from one speed to the next, simply
move the dial to the next speed mark and follow the instructions.
Start with the slowest speed setting. The machine
MUST BE AT TDC!
Do exactly as de-
scribed previously for single speed machines for the first variable speed (slowest speed).
Agjust Motor Speed For
Setting No. 2
Press ENTER When OK
to continue setup.
You will be asked to prepare for the next two speeds by increasing the machine’s speed to
the third and forth speed range until all four settings are determined.
Just as with the first (slowest setting) done previously, cycle the machine until the control
determines the proper stopping angle.
SPEED SETUP FOR No. 2
READY to CYCLE
PRESS PALM BUTTONS
Once the slowest speed has been entered the following screen will appear.
Change the machine’s speed to the next speed setting. (Second speed)
MACHINE SPEED SET UP
COMPLETED