Metal Fusion King Kooker OUTDOOR COOKER, Инструкция по сборке и эксплуатации

Страница: 16 / 40

CS28
CS28
Assembly Instructions
Assembly Instructions
Required Tools: Adjustable Wrench
Parts List:
(1) Cooker Frame
(2) Castings/Air Shutters
(1) Manifold Assembly
(1) Hose/Regulator
(4) Legs
(1) Windguard Shield
(2) Deep Fry Thermometers
(1) Locking Bracket
(1) Locking Bolt, (2)Washers and (2)Nuts
1) Review the contents in your package. Make sure all listed components for your model are
included.
2) Remove nuts from casting bolts. Flip the cooker frame upside down. Insert castings through the
shroud openings with the bolts pointed up. Place the casting bolts through the hole in the flat bar.
Reinstall nuts to casting bolts. Tighten. Turn frame right side up. Check to see if the castings are
pointing straight up and are sturdy.
3) Install the four legs into the top frame as pictured above. Snap in leg bolts through the receiving
holes on the frame. Make sure the leg bolts pop completely out and legs are securely locked in
position.
4) To attach windguard shield to the top frame, align the windguard shield to top frame as per above
diagram. Slide windguard into receiving U Clips welded to the cooker frame.
5) Locate the manifold assembly. Align the two male swivel fittings on the manifold to the venturi
tubes on the castings. Hand tighten the male swivel fittings into the castings. Once tightened, use an
adjustable wrench to tighten the swivel fittings an additional 1 to 1 1/2 turns.
6) Locate the hose/regulator. Tighten the hose fitting onto the manifold, as pictured above, with a
torque wrench, up to a torque of 95 to 105 lb./inch. Alternatively, hand tighten securely and then,
using a wrench, tighten an additional 1 to 1 1/2 turns.
7) Go to to the Use and Care section of this manual for further instructions.
8) For storage purposes a locking bracket and bolt are provided with this unit. After the cooker has
completely cooled, remove the windguard shield and legs. Lay the cooker upside down on a flat
surface. Wrench tighten locking bolt into the nut on center support. Fold windguard and place it long
side up across the center of the cooker with the locking bolt through the center hole. Place the legs
on top of the windguard alternating each foot in opposite directions. Place the locking bracket across
the four legs and over the locking bolt. Screw the washer, locking washer, nut and wingnut over the
locking bolt. Tighten to hold securely in place.
Leg
Windguard
Manifold Assembly
16
36825GAkk 3/29/06 10:53 AM Page 16