Metal Fusion King Kooker OUTDOOR COOKER, Инструкция по сборке и эксплуатации

Страница: 15 / 40

15
CS01 Assembly Instructions
REQUIRED TOOLS:
Adjustable Wrench
CS01 Parts List:
(1)Top Frame
(1)Casting/Air Shutter
(1)Hose/Regulator
(1)Thermometer
(4)Leg
(1)Bottom Shelf
(2)Side Work Shelf
(2)Support Bracket wtih U Clips
1) Review the contents in your package. Make sure all listed components for your model are included.
2) Remove top nut from casting bolt. Leave bottom nut attached and tightened. Flip cooker frame
upside down. Insert casting through the shroud opening with the bolt pointed up. Place the
casting bolt through the hole in the flat bar. Reinstall nut to casting bolt. Tighten. Turn frame
right side up. Check to see if the casting is pointing straight up and is sturdy.
3) Install the four legs into the top frame by matching the numbers on the legs to the numbers on
the leg receivers (for example: 1 to 1, 2 to 2, etc...) Snap in leg bolts through receiving holes on
frame. Make sure the leg bolts pop completely out and legs are locked in position.
4) Install bottom shelf into shelf clips on legs.
5) Hang side work shelves onto top frame using the U clips welded to frame. Attach support brackets to
side work shelves and bottom shelf as per diagram by fitting the U clip of one end of support
bracket to bottom of side shelf and the other end to the side of bottom shelf as pictured above.
6) Refer to Figure 1 pg. 9 for hose assembly instructions. Then go to the Use and Care Section of this manual for further
instructions.
1803PKP Work Table Assembly Instructions
Cooker
Frame
Work Table
1) Place edge of work table into U-clip receivers
on cooker frame to attach the work table
assemby to the cooker. See Picture.
2) Go to the Use and Care Section of this
manual for further information.
36825GAkk 3/29/06 9:49 AM Page 15