Metal-Fach GHT, Эксплуатационная и техническая документация, Страница: 19 / 32

19
Table 2. GHT 40 kW
Nominal heat output kW 40
Water capacity dm3 200
Fuel consumption at maximum power kg/h 9,5
Boiler weight kg 840
Maximum operating temperature
0C
95
Chimney draught Pa 10-17
Approximate chimney height
m 8
Stack section mm 160x250
Working pressure MPa 0,1
Storage capacity dm3 700 (13 bags)
Thermal efficiency % 88,4
Area of the room to be heated
m2
250-450
.
Explanations:
- In order to ensure proper boiler operation, the chimney section should be min. 150 mm for
boilers up to 30 kW.
- the area of the room related to well and medium insulated buildings with a heat loss factor of
80-110 W/m2
4.2. Boiler transport
Lifting and lowering of the boiler should be done by means of metal rods through the cleaning
door and the boiler flue gas outlet. When transporting the boiler, it must be secured against shifting
and tilting on the vehicle platform with belts, wedges or wooden blocks. The boiler must be
transported in vertical position. Otherwise, the steel jacket of the boiler insulation may be
damaged.
The boiler is delivered in an assembled condition. To make it easier to bring the boiler to its
destination, the fuel feeder can be disassembled by removing the boiler covers beforehand, and
the ceramic inserts can be removed from inside the furnace (fig. 14). When reassembling the
burner, seal it again with heat-resistant silicone (min. 300OC) and screw it on. The manufacturer
is not responsible for any disturbances caused by improperly assembled feeder parts. Removal
of such faults will be made against payment
.
The device is individually assembled from parts. The scope of delivery can be checked on the
basis of shipping documents.
Immediately upon receipt of the machine, it must be ascertained whether the scope of delivery is
in accordance with the delivery note. In the case of a delayed claim for defects, the supplier shall
not be liable.
Any identified transport damage should be immediately reported to the supplier, and deficiencies
or discrepancies should be reported to the manufacturer.