17
Assembly manual FS2 EI60/120 Version 11, jan.. 2021
-
Connect the motor to the MO710 controlbox on wire 4 and 5
on the 24V DC and the wires 1,2 and 3 on the adjusting cable.
Send the screen down gently, if necessary accompany the first
time. Adjust the motor down and up with the two adjusting
screws on the motor. Pay attention to the direction of rotation
of the shaft. See also the manual of the engine supplier.
8.2 Installation of the curtain descent mechanical (angle bar).
CAUTION!
This Section applies to curtain doors with gravity descent
.
-
With the shaft installed, run the drive motor in the curtain closing direction.
-
With the curtain unwound down to the floor surface, mark out the curtain descent mechanical stop
(30x30 wide angle bar). Next, turn the shaft to rivet / secure the angle bar
(with 4x13 rivets or 4x25 self-drilling screws, depending on the curtain door size).
-
When drilling with the tubular motor, make sure you do not drill too deep and damage the motor
.
-
Image adjusting cable motor
Marked out angle
barinstallation location
Shaft shown turned
inposition for securing the
angle bar
Image Installation of the curtain descent mechanical (angle bar)
