18
ENGLISH
Transport
1.
Swing the sawhead down and insert
the transport locking pin
(31)
.
2.
Dismount all add-on parts projecting
from the machine.
3.
Lift machine by the carrying handle.
45
q
cutting angle range for bevel
cuts, sawhead tilted to the left.
92
q
cutting angle range for mitre
cuts (46
q
left through 46
q
right) with
nine preset stops.
Precise and sturdy die-cast alumin-
ium construction.
TCT saw blade.
Unproblematic saw blade change
with the saw blade lock.
Maximum cutting depth 65 mm.
ON/OFF switch (32)
x
To turn the motor ON:
Press and hold the ON/OFF
switch.
x
To turn the motor OFF:
Release the ON/OFF switch.
Bevel tilt setting
After loosening the tilt lock screw
(33)
at
the rear the sawhead can be tilted conti-
nously from 0° (vertical) through 45°.
Rotating table
The rotating table can be turned after
loosening the lock screw. This way the
cutting angle is changed against the
guide edge of the work piece. Angles up
to 47° left and right are possible.
The rotating table engages into positive
stops at the 0°, 15°, 22.5°, 30°, and 45°
position.
Laser guide ON/OFF switch
The laser guide is enabled with the ON/
OFF switch
(35)
.
The laser guide is turned ON by the
push button
(34)
when swinging the
sawhead assembly down. Only now the
red cutting line marking appears on the
work surface.
7.1
Installation of the Dust
Bag
A
Danger!
Some types of wood dust (e.g.
oak, beech, ash) may cause cancer
when inhaled.
x
Always work with the dust bag
installed or a suitable dust collec-
tor connected.
x
In addition, use a dust respirator,
because the saw dust is not com-
pletely collected or extracted
respectively.
x
Empty the dust bag periodically.
Wear a dust respirator when emp-
tying the dust bag.
When operating the machine with the
dust bag supplied:
x
Push the dust bag on the dust
extraction port.
x
Make sure that the dust bag's zipper
is closed.
When operating the machine with a dust
collector connected:
x
Use a suitable adaptor for connect-
ing the dust collector.
x
Make sure the dust collector com-
plies with the following require-
ments:
air flow volume
t
460 m
3
/h;
vacuum at the dust extraction
port of the saw
t
530 Pa;
air speed at the dust extraction
port of the saw
t
20 m/s.
x
Also follow the operating instruc-
tions supplied with the dust collec-
tor!
7.2
Mains Connection
B
Danger! High voltage
x
Operate this machine in dry sur-
roundings only.
x
Operate the machine only on a
power source meeting the follow-
ing requirements (see also "Tech-
nical Specifications"):
mains voltage and system fre-
quency conform to the voltage
and frequency shown on the
machine´s rating label;
fuse protection by a residual
current operated device (RCD)
of 30 mA sensitivity;
outlets properly installed,
earthed, and tested.
x
Position power supply cable so it
does not interfere with the work
and is not damaged.
x
Protect power supply cable from
heat, aggressive liquids and
sharp edges.
5.
Special Product Features
6.
Machine Details
32
33
34
35
7.
Initial Operation
