
10
2.2.6 Connecting Wires
To fulfil the waterproof functionality, it is necessary to utilize the included rain-tight compression kit while connecting wires
with the camera. First thread the required Ethernet wire through the compression cap and compression core in proper order
followed by threading the cable into the rear cap to connect with the corresponding port/interface on the rear panel. The 4
holes embedded within the compression core are spare for multiple wires thread and need to be blocked out via plugs when
not in use. Finally, assemble the compression kit together and rotate the compression cap clockwise to compress the kit
tightly in case of liquid leak. After that, be sure to assemble the rear cap back to the camera body by fastening the 2 screws.
Compression Cap
Compression Core
Plugs
Figure 2 - 6: Connecting Wires
For the details of ports/interfaces (power, audio, alarm, internet) that correspond to connecting wires, please refer to the
previous chapter “
1.1 Physical Characteristics
” for more elaborations.
Caution
Never connect more than one type of power supply (PoE+ (IEEE 802.3at) and AC 24V) at the same time
in case of damage to the camera.