MERRICK MC3 90.10.EX, Руководство по эксплуатации и техническому обслуживанию

Страница: 28 / 59

MC³ 90.10.EX O&M Manual - 21 -
Settings Menu
Entering New Values
Numeric Screen Example
Most values are entered into the Controller via a numeric entry screen (see the above example).
This screen shows the name of the parameter, the current value, units and the minimum and
maximum allowed values for the parameter. If there are three or more related parameters, the
controller displays three at a time otherwise the controller will only show one parameter. The
active parameter is enclosed in a rectangle. This is the value that any button entry will act upon.
First find the parameter to be changed by using or buttons to scroll. Then press the
button to clear the current value for a new entry.
Enter the new value for the selected parameter using the numeric buttons. The display will show
the value area as they are entered.
If the value is correct press the button to save this value. The controller tests the
number to insure that it is a valid entry. If the number is within the minimum and maximum values
a message will appear under the parameter list:
If the value is incorrect, press the button and re-enter the value. If the value is not
within accepted limits, the following message will appear:
NOTE: The current engineering units will be shown for the parameter being displayed.
Units Select
Use the Up or Down arrow buttons to scroll through the list of units until the combination appears
in the center box that is correct for your application.
NOTE: When weight is displayed in the menu system, the units will follow the setting for load.
Total Feedrate
Lb lb/min
Lb lb/h
TN lb/min
TN lb/h