COPYRIGHT © 2005 MERIT INDUSTRIES, INC.
ATTENTION:
OBSERVE PRECAUTIONS FOR HANDLING ELECTROSTATIC DEVICES
Removal/Installation of Major Assemblies -
MAXX Select/Slim MAXX Countertop (cont’d)
Troubleshooting Information - Removal/Installation of Major Assemblies -
MAXX Select - Slim MAXX Countertop
Megatouch MAXX Technical Reference Manual
4. Remove the screw and washer fastening the hard drive mounting plate to the CPU tray and
carefully pull the hard drive assembly away from the game. See Figure 2.
5. Remove the 4 screws and shoulder washers fastening the hard drive to the mounting plate.
See Figure 2.
6. Remove the grommet surrounding the wires on the 4-pin power connector from the cutout in
the hard drive mounting plate in order to allow room to disconnect the connector from the drive.
Then disconnect both the power connector and the hard drive ribbon cable from the hard drive
and remove the drive. See Figure 2.
Hard Drive Installation
1. Connect the power connector and ribbon cable to the new hard drive.
2. Replace the grommet surrounding the wires on the power connector in the cutout in the hard
drive mounting plate, then fasten the drive to the mounting plate with the 4 screws and shoulder
washers. See Figure 2.
3. Place the hard drive assembly in the game and fasten the mounting plate to the CPU tray with
the screw and washer. See Figure 2.
4. Slide the CPU shelf back into the game until the spring-loaded pin clicks in place.
5. Close and lock the rear door.
6. Plug in and turn on the game.
Monitor Removal
1. Turn off and unplug the game.
2. Unlock and remove the coin mech from the game.
3. Unlock and open the rear door.
4. Remove the 2 thumbnuts securing the hood, slide the hood back, and remove it.
5. Lift the spring-loaded pin and carefully slide the CPU shelf out from the game and into its
service position. See Figure 1.
6. Disconnect the monitor power connection (black and white wires running from the monitor
board to the right angle connector plugged into the power supply).
7. Disconnect the monitor signal cable from the motherboard.
8. Remove the two screws fastening the touchscreen controller (see Figure 1) to the game and
remove the controller. Then disconnect the touchscreen controller cable from the back of the
controller and disconnect the Molex connector (orange and gray wires) running from the
touchscreen controller cable to the main power harness.
9. Loosen the thumbnut securing the power supply mounting bracket to the monitor assembly.
10. Remove the 4 screws on top of the front bezel and the 2 screws (one on each side) fastening
the front bezel to the game, then separate the bezel from the monitor.
11. Remove the 3 nuts (one on each side, one on the bottom of the game along the edge opposite
the power switch) securing the monitor assembly to the game and remove the monitor from
the cabinet.
Содержание MAXX Upright
Страница 39: ...Section 2 Hard Drive Information Hard Drive Numbers Program Numbers Part Numbers Security Key Numbers...
Страница 90: ...Section 5 Motherboards Circuit Board Cross Reference Chart Telco Mitsubishi Itox Unicorn I O Board Pinouts...
Страница 98: ...Section 7 Technical Service Bulletins...