COPYRIGHT © 2005 MERIT INDUSTRIES, INC.
ATTENTION:
OBSERVE PRECAUTIONS FOR HANDLING ELECTROSTATIC DEVICES
Removal/Installation of Major Assemblies -
EZ MAXX/MAXX Elite Countertop (cont’d)
Troubleshooting Information - Removal/Installation of Major Assemblies -
EZ MAXX/MAXX Elite Countertop
Megatouch MAXX Technical Reference Manual
5. Replace the centronics cable in the cable clamp.
6. Close and lock the rear door.
7. Plug in and turn on the game.
Monitor Removal
1. Turn off and unplug the game.
2. Unlock and open the rear door.
3. Disconnect the monitor power connection (black and yellow wires) running to the power
supply.
4. Disconnect the monitor signal connector from the motherboard, then remove the cable from
the clamps.
5. Inside the game, access the latches for each side panel and remove both panels (see Figure
2).
6. Remove the two nuts and washers securing the touchscreen controller to the game and re-
move the controller from the mounting screws. Then disconnect the cable from the back of the
controller and disconnect the Molex connector connecting the orange and gray wires (from the
touchscreen controller cable) to the main power harness.
7. Remove the 3 screws at the top of each side piece fastening the top cover to the game (see
Figure 3) and remove the top cover.
8. Loosen the 5/16” nuts securing the 2 LCD clips (one on each side piece). See Figure 3.
9. Lift the bezel and monitor assembly from the game.
Monitor Installation
1. Place the new monitor assembly in the game.
2. Secure the 2 LCD clips by tightening the 5/16” nuts (see Figure 3).
3. Fasten the top cover to the game with the 3 screws at the top of each side piece (see Figure 3).
4. Connect the touchscreen controller cable in the back of the controller, then fasten the controller
to the game with the existing hardware. Also connect the Molex connector (orange and gray
wires) to the main power harness.
5. Replace both side panels.
6. Replace the monitor signal cable in the clamps, then connect the cable to the motherboard.
7. Connect the monitor power connector to the power supply.
8. Close and lock the rear door.
9. Plugn in and turn on the game.
Touchscreen Removal
1. Turn off and unplug the game.
2. Unlock and open the rear door.
Содержание MAXX Upright
Страница 39: ...Section 2 Hard Drive Information Hard Drive Numbers Program Numbers Part Numbers Security Key Numbers...
Страница 90: ...Section 5 Motherboards Circuit Board Cross Reference Chart Telco Mitsubishi Itox Unicorn I O Board Pinouts...
Страница 98: ...Section 7 Technical Service Bulletins...
