COPYRIGHT © 2005 MERIT INDUSTRIES, INC.
ATTENTION:
OBSERVE PRECAUTIONS FOR HANDLING ELECTROSTATIC DEVICES
Removal/Installation of Major Assemblies -
MAXX Upright
Troubleshooting Information - Removal/Installation of Major Assemblies -
MAXX Upright
Megatouch MAXX Technical Reference Manual
Monitor Removal
1. Turn off and unplug the game.
2. Unlock and open the rear door to gain access to the monitor. See Figure 2.
3. Disconnect all harnesses from the monitor.
4. Remove the two nuts and washers securing the touchscreen controller to the game (see Fig-
ure 3) and remove the controller from the mounting screws. Then disconnect the cable from
the back of the controller and disconnect the Molex connector (orange and gray wires) running
from the touchscreen controller cable to the main power harness.
5. Remove both bolts securing the rear of the monitor shelf to the cabinet. See Figure 3.
6. Unlock and open the front bezel.
7. Remove both bolts securing the front of the monitor shelf to the cabinet (located on the under-
side of the shelf). See Figure 3.
8. Remove the ground strap attached to the monitor.
9. Pull the monitor up and out through the front of the game.
Monitor Installation
1. Place the new monitor in the game.
2. Replace the ground strap on the monitor.
3. Secure the front of the monitor shelf to the cabinet with the 2 bolts. See Figure 3.
4. Close and lock the front bezel.
5. Secure the rear of the monitor shelf to the cabinet with the 2 bolts. See Figure 3.
6. Connect the new touchscreen cable in the back of the controller and secure the controller on
the mounting screws in the game with the existing hardware (see Figure 3). Also connect the
Molex connector (orange and gray wires) to the main power harness.
7. Reconnect all harnesses to the monitor.
8. Close and lock the rear door.
9. Plug in and turn on the game.
Touchscreen Removal
1. Turn off and unplug the game.
2. Unlock and open the front bezel.
3. Remove the black poly tape from around the edges of the old touchscreen, keeping the manner
in which the tape was placed around the screen in mind.
4. Remove the two nuts and washers securing the touchscreen controller to the game (see Fig-
ure 3) and remove the controller from the mounting screws. Then disconnect the cable from
the back of the controller and disconnect the Molex connector (orange and gray wires) running
from the touchscreen controller cable to the main power harness.
Содержание MAXX Upright
Страница 39: ...Section 2 Hard Drive Information Hard Drive Numbers Program Numbers Part Numbers Security Key Numbers...
Страница 90: ...Section 5 Motherboards Circuit Board Cross Reference Chart Telco Mitsubishi Itox Unicorn I O Board Pinouts...
Страница 98: ...Section 7 Technical Service Bulletins...