COPYRIGHT © 2005 MERIT INDUSTRIES, INC.
Troubleshooting Information - Removal/Installation of Major Assemblies -
Full MAXX
Megatouch MAXX Technical Reference Manual
ATTENTION:
OBSERVE PRECAUTIONS FOR HANDLING ELECTROSTATIC DEVICES
Removal/Installation of Major Assemblies -
Full MAXX (cont’d)
Hard Drive Installation
1. Plug the power connector and ribbon cable into the new hard drive.
2. Fasten the cable clamp to the hard drive with the 2 screws (1 per side), then secure the hard
drive to the mounting brackets with the 4 screws and shoulder washers. See Figure 3.
3. Attach the hard drive assembly to the electronics box by tightening the 4 screws that fasten the
hard drive brackets to the box.
4. Place the electronics box in the game and reconnect all harnesses disconnected in step 4
above, then fasten the electronics box with the 6 screws (3 per side, see Figure 2).
5. Replace the back plate along the bottom of the game, then reconnect the 2 fan power connec-
tors and replace the electronics box access panel. Secure the panel with the 2 thumbnuts.
See Figure 1.
6. Replace and lock the lid.
7. Plug in and turn on the game.
Monitor Removal
1. Turn off and unplug the game.
2. Unlock and remove the coin mech from the game.
3. Unlock and remove the lid.
4. Unscrew the 2 thumbnuts and remove the electronics box access panel at the rear of the
game. You will need to unplug the 2 fan power connectors in order to completely remove the
panel. Also remove the black plate along the bottom of the game. See Figure 1.
5. Remove the 6 screws (3 per side, see Figure 2) fastening the electronics box to the game
chassis, then slide the box towards you and disconnect all necessary harnesses until you can
completely remove the box and access the monitor. Remember which harnesses were dis-
connected.
6. Disconnect the monitor power connection (black and white wires running from the monitor
board to the right angle connector plugged into the power supply).
7. Disconnect the monitor signal cable from the motherboard.
8. Remove the two nuts and washers securing the touchscreen controller to the game and re-
move the controller from the mounting screws. Then disconnect the touchscreen controller
cable from the back of the controller and disconnect the Molex connector (orange and gray
wires) running from the touchscreen controller cable to the main power harness.
9. Remove the 2 nuts securing the monitor assembly to the cabinet base on the cash box side.
10. Loosen (do not remove) the 2 nuts securing the monitor assembly to the cabinet base on the
side opposite the cash box.
11. Slide the monitor assembly back and lift it off the mounting studs until you’re able to remove it
from the game.
Содержание MAXX Upright
Страница 39: ...Section 2 Hard Drive Information Hard Drive Numbers Program Numbers Part Numbers Security Key Numbers...
Страница 90: ...Section 5 Motherboards Circuit Board Cross Reference Chart Telco Mitsubishi Itox Unicorn I O Board Pinouts...
Страница 98: ...Section 7 Technical Service Bulletins...