COPYRIGHT © 2005 MERIT INDUSTRIES, INC.
Troubleshooting Information - Removal/Installation of Major Assemblies -
Full MAXX
Megatouch MAXX Technical Reference Manual
ATTENTION:
OBSERVE PRECAUTIONS FOR HANDLING ELECTROSTATIC DEVICES
Removal/Installation of Major Assemblies -
Full MAXX (cont’d)
Monitor Installation
1. Place the new monitor assembly on the mounting studs in the game.
2. Tighten the 2 nuts to secure the monitor assembly to the cabinet base on the opposite side of
the cash box.
3. Replace the 2 nuts to secure the monitor assembly to the cabinet base on the cash box side.
4. Route the new touchscreen controller cable under the picture tube and away from the flyback
transformer. Then reconnect the cable in the back of the controller and secure the controller on
the mounting screws in the game with the existing hardware. Also connect the Molex connec-
tor (orange and gray wires) to the main power harness.
5. Reconnect the monitor signal cable to the motherboard.
6. Reconnect the monitor power connector.
7. Place the electronics box in the game and reconnect all harnesses disconnected in step 5
above, then fasten the electronics box with the 6 screws (3 per side, see Figure 2).
8. Replace the back plate along the bottom of the game, then reconnect the 2 fan power connec-
tors and replace the electronics box access panel. Secure the panel with the 2 thumbnuts.
See Figure 1.
9. Replace and lock the lid.
10. Replace and lock the coin mech.
11. Plug in and turn on the game.
Touchscreen Removal
1. Turn off and unplug the game.
2. Unlock and remove the coin mech from the game.
3. Unlock and remove the lid.
4. Unscrew the 2 thumbnuts and remove the electronics box access panel at the rear of the
game. You will need to unplug the 2 fan power connectors in order to completely remove the
panel. Also remove the black plate along the bottom of the game. See Figure 1.
5. Remove the 6 screws (3 per side, see Figure 2) fastening the electronics box to the game
chassis, then slide the box towards you and disconnect all necessary harnesses until you can
completely remove the box and access the hard drive. Remember which harnesses were
disconnected.
6. Disconnect the monitor power connection (black and white wires running from the monitor
board to the right angle connector plugged into the power supply).
7. Disconnect the monitor signal cable from the motherboard.
8. Remove the two nuts and washers securing the touchscreen controller to the game and re-
move the controller from the mounting screws. Then disconnect the touchscreen controller
cable from the back of the controller and disconnect the Molex connector (orange and gray
wires) running from the touchscreen controller cable to the main power harness.
Содержание MAXX Upright
Страница 39: ...Section 2 Hard Drive Information Hard Drive Numbers Program Numbers Part Numbers Security Key Numbers...
Страница 90: ...Section 5 Motherboards Circuit Board Cross Reference Chart Telco Mitsubishi Itox Unicorn I O Board Pinouts...
Страница 98: ...Section 7 Technical Service Bulletins...
